Sliding Gate Operators,Automatic Sliding Door |
The sliding gate operators are used to drive sliding gates for industrial,
commercial and residential uses. The operators can be fitted with gear
wheel or chain wheel according to your needs, and featured with powerful
starting strength, capable of overwork at short time. In case of power
failure, an emergency release key allows operate gate manually.
|
Sliding gate
|

Extension sliding gate
|
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- |
Gear-drive or chain-drive is optional
Magnetic or spring limit switch is optional
The self-locking electromechanical gear motor keeps the gate completely
closed
Motor torque adjustment
Stop on closing if it hits obstruction
Overheat & Overload dual protection
Emergency release key in case of power failure
Control panel wiring are available to alarm lamp, remote controller,
photocells, loop detector and IC card, etc.
Available in DC24V version, which can be operated by two storage
batteries DC12V each.
|
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- |
|
Model:CB-04(customer exclusive) Sliding Gate Operators
1=Network filter protection 2=Power supply transformer 3=Radio module 434MHz frequency 4=Connector for inclusion of CB-RF quarzate radiofrequency board 5=Adjustment of motor strength and deceleration 6=Opto-insulated switchboard inputs with LED display 7=Programming via dip-switch 8=Relay output for control of motors 9=F1 NEUTRAL safety fuses power voltage 6.3A/250v AC 10=F2 PHASE safety fuses power voltage 6.3A/250v AC 11=Auto-reinstating fuse power voltage 24v AC 11=Auto-reinstating fuse power voltage 12v AC
User Mannual: CB-04(customer exclusive)
Gear wheel & Magnetic limit
switch
The self-locking gear motor
Safety Obstruction Reverse (An infrared photocells must be installed)
Overheat & Overload dual protection
Emergency release key in case of power failure
Control panel wiring are available to alarm lamp, remote control, photocells,
loop detector, IC card. |
|
|
![Inside view]()
|
|
3530 |
 Gear rack
- 1005*30*12mm
- Module = 4
- Galvanized
- 4 pcs/carton
|
|
|
|
|
|